< DATA SETUP > The Rec# and Date on the setup data are displayed. Select the Rec# and set the data to the Drive and then click "Exec" button. <> Insert the latest ** to the CD drive and press "Enter" key. When you want to cancel, press "Esc" key. CD isn't inserted into the drive. When "Enter" key is pressed, the system starts copying. When "Esc" key is pressed, there is no process. The user must press "Enter" key after setting the CD to the drive, or press "Esc" key to cancel the setup. <> The data cannot be copied. Check the [Data Configuration]. The system found an error while copying the data. The system canceled the copy of the data. The user must check the Data Configuration and try again. <> Is it OK that the CD you set is older than the setup CD ? The CD in the drive is older than the setup CD. When "Yes" button is clicked, the system deletes all data on the Rec#s which are later than the Rec# to be set and continues the process. When "No" button is clicked, the system cancels the process. The user must click "Yes" button to setup the old CD or click "No" button to cancel the process. <> Not enough space in drive. The system cannot setup because of the insufficient hard disk space. None. The user must increase the hard disk space and try again. <> code=XXXX I print a screen, and please refer to an inquiry window. The system found an error and cannot proceed. The system closes the EPC, when "End" button is clicked. The system outputs hard copies and closes the EPC, when "Print" button is clicked. The user must click "End" button in the message box to close the program or click "Print" button to print the screen, and report to the consultant.