< PART NUMBER APPLICATION TO MODELS > 1. Enter Part Numbers. All the Catalog Codes with these Part Numbers will be diplayed with their Vehicle Model Information. * The substituted Part Number is displayed below the Part Number. 2. You can enter maximum of 10 Part Numbers. 3. You can search Rec#s. 4. You can search Abbreviations, after Models are displayed. <> Select the Part Number you want to delete. Part Number isn't selected. None The user must select the Part Number to be deleted and click "Delete" button <> Enter a Part Number and press enter key. "Exec" button was clicked without selection of Part Number. None The user must enter the Part Number and press "Enter" key and then click "Exec" button. <> You can enter maximum of 10 Part Numbers. More than 10 Part Numbers were entered. None The user must select the already entered Part Number and delete it, or click "Clear" button to delete the all Parts Number and try again. <> Enter 10 or 12 digits part number(s), and press F10. "Enter" key was pressed with the wrong digit of Part Number. None The user must enter the Part Number of 10 or 12 digits and try again. <> This Part Number has been already entered. The entered Part Number has been already selected to search. None The user must check the input and select the process. <> Do you want to print the Part Number Application to Models? The printing is executed. When "Yes" is clicked, a list is output. When "No" is clicked, there is no process. The user must click "Yes" to contine the printing or click "No" to cancel the printing. <> code=XXXX I print a screen, and please refer to an inquiry window. The system found an error and cannot proceed. The system closes the EPC, when "End" button is clicked. The system outputs hard copies and closes the EPC, when "Print" button is clicked. The user must click "End" button in the message box to close the program or click "Print" button to print the screen, and report to the consultant.